Glitter Heat Transfer Vinyl Glitter is CPSIA Certified so it's perfect for decorating children's clothing and accessories. | |
Specifications: PU composition • Pressure sensitive backing • Glitter finish • 325 Microns/12.8 Mils • 45°/60° blade • Do not layer |
CUTTER SETTINGS | |||
Cricut: Blade: Standard Setting: Iron-On + | Silhouette Cameo: Blade: Standard, 4 Material: Heat Transfer, Smooth Speed: 8 Force: 11 | Scan N Cut: Blade: Standard, 3 Cut Speed: 1 Cut Pressure: 5 | |
Roland GS/GX-24: Blade: 45° Gram Force: 180-190 Offset: 250 Speed: 30 cm/s | Graphtec: Blade: 45° Gram Force: 17 Tool: CB09U+0 Speed: 30 cm/s | MH, SC2, LP3, Titan 1: Blade: 45°/60° Gram Force: 120-130 Speed: 300 mm/s *Blade Advancing Varies | Titan 2 & 3 Blade: 45°/60° Gram Force: 100-110 Speed: 300mm/s *Blade Advancing Varies |
Settings may vary based on blade condition and age of machine. Always perform a test cut prior to cutting designs. |
APPLICATION INSTRUCTIONS | |
Application Instructions (home iron) • Set iron dial between Cotton and Linen • Cover design with Kraft paper or non-stick cover sheet • Place on flat, hard surface (ironing board not recommended) • Press iron with medium/firm pressure (do not slide iron) • Press each section of design for 10-15 seconds • If areas of design lift after application, replace cover sheet and re-press for 10 seconds • Peel carrier warm | Application Instructions (heat press) • Cut in Reverse • Weed excess material • Preheat garment for 2-3 seconds • Apply design at 320°F/160°C • Use firm pressure for 15-20 seconds • Peel carrier warm |
RECOMMENDED ACCESSORIES & CARE | |||
Glitter Applies to: 100% cotton Poly/cotton blends 100% polyester Leather | Recommended Accessories: Siser Weeder | Laundering: Wait 24 hours before 1st wash Machine wash warm or cold / mild detergent Dry on normal dryer setting Do not dry clean |