1. Connect one end of the water tube to the nozzle of the wet model trimmer and the other end to the tap, open the valve
2. Connect the waste-disposal tube to the unit
3. Connect the power cord, and switch on the power switch (O=off, l=on)
4. When braking, it is normal to hear clicking before the sand tablet stops. If the sand tablet makes unusually loud noises, remove it, and use the included hex-wrench to adjust the screw on the back cover (18)
5. To check if you need to replace the abrasive disk, rotate the disk by hand and estimate: if the platform jumps more than 2mm, change the disk. After replacing the disk, make sure to tighten the ring on the platform 8 (closest to the outside of the sand tablet)
Attention:If there is some abnormal noise when working on
Possible reason : ① Axon is loosing ② Disc is not plain enough 。
How to solve it : ① Dissemble the disc ⒃ with spanner , make the snap
Ring tightly ; ② change the disc 。
The machine does not work when power on
Possible reason : ① fuse get burnt ; ② motor get burnt ; ③ switch get wrong 。
How to solve it : ① change the fuse ( 22 ) which inside the socket ; ② change the motor ③ change the switch
SpecificationsVoltage: 110V/60Hz
Power: 500W Rotational Speed: 2800 rpm
Dimensions: 44×35×35cm Weight of the dental trimmer: 20kg
Content:
1x JT-19 Wet Model Trimmer Abrasive Disc Wheel Dental Lab Equipment
Shipping notice | Can not ship to Puerto Rico/Alaska/Hawaii |
---|---|
Brand | Unbranded/Generic |
MPN | Does Not Apply |
Voltage | 110V/60Hz ± 10% |
Model | JT1502X+JT19X |
Warranty | 1 Year |
UPC | Does not apply |
Shaker Type | Platform Shaker |