ICL8038 Monolithic Function Signal Generator Module DIY Kit Sine Square Triangle

ICL8038 Monolithic Function Signal Generator Module DIY Kit Sine Square Triangle Wave

Description:

ICL8038 pin functions:

Pin 1, Pin 12: sine waveform adjusting terminal;

Pin 2:  sine wave output;

Pin 3: triangle wave output;

Pin 4, Pin 5: the frequency and duty cycle (or waveform asymmetry) adjustment;

Pin 6: V +, the positive power supply;

Pin 7: Frequency Offset;

Pin 8: Frequency adjustment input terminal;

Pin 9: square wave output. This is an open collector output terminal, work should take a load resistor to the corresponding positive power supply terminal from the pin, to get a TTL-compatible square-wave output, the load resistance must be connected to + 5V power supply;

Pin 10: timing capacitor terminal;

Pin 11: V-, negative power supply terminal or the ground. When Use positive and negative power supply, Pin 11 to the negative supply, the output waveform are symmetrical with respect to 0 V; When use a single positive power supply, Pin 11 grounded, the output waveform is unipolar, uniform voltage is + VCC / 2;

Pin 13 and Pin 14: Empty Pin.

The kit is designed for a frequency range is 50-5KHz, two bands with using a switch S to switch, RP1 is the frequency adjustment, RP2 is the duty cycle adjustment, RP3 is a sine wave distortion adjustment. Circuit uses 12V single power supply, input from the X1; X2, X3 is a waveform output side, you can use oscilloscope to observe three output waveforms.

Model: ICL8038

Input:  12V DC

Frequency range: 50-5KHz,

Package Included:

1 * DIY ICL8038 Function Signal Generator Module Sine Square Triangle Wave Output KIT

Note: Please contact us if you need the Schematic.

• Condition: New
• Brand: Unbranded